| Measurement Solutions Product Guide |
 Order A Catalog NEW Available In Spanish |
| Electronic Measurement Solutions Catalog |
 Order A Catalog |
| Pressure Measurement Solutions Catalog |
 Order A Catalog |
Home > Permanent Diaphragm Seals > Type 12 Tri-Clamp Sanitary Pressure Diaphragm Seals
> Product Specifications
Type 12
Type 12
Tri-Clamp Sanitary Pressure Diaphragm Seals
Product Specifications
Click here to enlarge chart - Printable PDF
| PRODUCT SPECIFICATIONS | |
| Suitable Pressure Gauge Sizes |
2½, 4, 4½ and 6 inch Will also operate with most transducers, transmitters and pressure switches |
| Minimum Working Pressure |
0 psig to 30 psig through -30 HG to 600 psig |
| Maximum Working Pressure |
Maximum Operating Pressure is Determined by the Clamping Device and Piping System - Please consult factory |
| Operating Temperature |
Refer to fill fluid expansion factors table below |
Note: NOSHOK pressure transmitters or transducers are not to be used in heat sterilization system as stated in 3A Standard 74-03 paragraph D10.1.2
Diaphragm seal must be installed facing downward or in a vertical position for drainability.
Do not install diaphragm seal facing in an upward position.
Click on table below to enlarge - Printable PDF
