| Measurement Solutions Product Guide |
 Order A Catalog NEW Available In Spanish |
| Electronic Measurement Solutions Catalog |
 Order A Catalog |
| Pressure Measurement Solutions Catalog |
 Order A Catalog |
400 Series Hard Seat Needle Valves
- 100% helium leak tested to 1 x 10-4 ml/s for guaranteed performance and reliability
- 10,000 psi pressure rating (@ 200°F maximum)
- Blow-out proof stem provides a secondary stem seal in the full open position
- Viton® o-ring seal and Teflon® back-up ring below the stem threads to protect from corrosion and galling; Teflon® or Grafoil® packing optional
- All stem threads are 316 stainless steel
- All stem threads are rolled for strength and ease of operation
- One-piece bonnet with a metal-to-metal seal to the valve body below the bonnet threads
- Bonnet lock pin to prevent accidental loosening
- Vinyl bonnet and stem dust cap
- Optional panel mount bonnet and panel nuts
- Grafoil® is a registered trademark of Graftech International
- Viton®, Delrin® and Kalrez® are registered trademarks of DuPont Performance Elastomers
- Teflon® is a registered trademark of DuPont Plastic
- Parco® is a registered trademark of Parco, Inc.
- Simriz® is a registered trademark of Simrit, A Division Of Freudenberk-NOK
- Parker® is a registered trademark of Parker O-Ring Division
- Ketron® is a registered trademark of Quadrant Engineering Plastics
- KEL-F® brand is a registered trademark of 3M. Production of this brand was discontinued in 1995. The only remaining brand, Neoflon®, is made by Daikin Industries of Japan. This PCTFE resin has the same chemical structure and properties as the original KEL-F® brand material
Click on chart below to enlarge
Click on chart below to enlarge
To meet all of your specific application requirements, the following additional options are available for these needle valves. To order all or any of these options, simply add them to the part number as shown in the diagram below.
NOTE 1: The example shown includes ALL possible additional options. Please include ONLY the options required for your application when building your part number. (EXAMPLE: 404-FFC-PM2)
NOTE 2: When a packing option is selected, an o-ring option is NOT available.
NOTE 3: Packing options are NOT available on 3/4" through 1-1/2" valves.
Click on chart below to enlarge
Click on chart below to enlarge
The standard o-ring in all the NOSHOK Valves is Viton® and the standard handles are: "T" handles (HL2)
The handle material will always match the material of the valve, unless otherwise specified. For example, the "T" handle (HL2) on the 404-FFC will be steel. When only the standard configuration is needed, no additional designations are necessary. Please consult the factory for special application requests.
* For 1/4" NPT to 1/2" NPT
** For 3/4" NPT to 1½" NPT